This product supports both manual knob dimming and remote control dimming.
Remote control compatible is: HX-RFBT10 (4 zone, adjust PWM value) HX-RFBT-DIM-2.4G(Single zone)
Dimmer can be controlled by any one the same remote as factory default; remote control delivered with unique RF code as factory default; if unique-control is needed, please matching the code before installation and using. Please refer to the corresponding remote-control manual for operation instruction in detail.
Connection port instruction:
Direction for use
Connect the load wire at first, followed by the power wire; Please ensure short circuit can not occur between connecting wire before turning on the power;
Adopt rotary button, function as follows: Clockwise rotation to brighten up brightness to 100% as the maximum; Counterclockwise rotation to dim down the brightness to 0% as the minimum.
PWM display: P005 stands for 500Hz, P010 stands for 1KHz, P020 stands for 2KHz(factory default), P040 stands for 4KHz, P078 stands for 7.8KHz, P156 stands for 15.6KHz.
Receivers will transmit the control signals from the remote control and self-inspection the work statues for each other, so multiple receivers in same zone will wireless-sync-work completely.
1.The working voltage is DC12V~24V, and it must not be connected to other voltages;
2.Ensure that the wiring is correct and no short circuit before power-on;
3.It supports wireless-sync-dimming by remote control, please refer to the remote control setting manual for details;
4.PWM dimming frequency is adjustable via remote control. The maximum output load power corresponding to different PWM frequencies is different. Please do not overload it.
PWM Frequency Adjustment operation :
Press and hold the remote control “Set” for 10 seconds after switch off the dimmer by remote control(the dimmer is in off state) within10 seconds, display will show as: P***. Means enter “PWM adjusting” state. Press Brightness+/- keys to adjust the PWM frequency, there is 6 levels optional, pressing “Set” button again to save it after finish the setting operation. Then the dimmer return to power on state.
Please note: PWM setting operation should be finished within 1 minute, Will automatically exit PWM adjusting status without save it after 60 seconds.
5.Warranty of this product is three years, exclude the artificial situation of damaged or overload working.